08-12-2017, 09:06 PM
|
BAR 13790
|
|
Join Date: May 2008
Location: Johnson City, NY
Posts: 524
|
|
I ran into a problem. The one tube did not bond well plus there was a gap between the cardboard pieces. I was able to cut apart the pieces. I then trimmed the main body stock to properly fit the tube (a little less than 1/8"). Forgot to grab a picture of the problem.
While the tubes were drying (again) I built the motor mount. It consists of the motor tube, motor block, motor hook, and center ring. I did substitute some kevlar thread for the shock cord where it connects to the motor mount tube
|